so, i enter latitude : 54.732 north, longitude : 6.216 WEST? into the receiver. because my longitude is minus do i change it to west?
yes
also, on the motor do i set the latitude to 54/55°? if you answer yes to this do i make adjustments via the bracket connected to the motor eg for elevation an such? rather than tweak the motor after setting the latitude?
you should have 2 brackets like this depending on the make of motor and the fittings that came with the dish
the bracket which attaches the motor to the wall mount will need to be set at 35 degrees (i think looking at your latitude? there should be a chart which came with the motor which will have the elevation angles) the angle on the dish bracket could vary depending on a few factors and is the one i make adjustments to once i think the dish is pointing in the right direction
from your earlier post it sounds like you have the dish/motor set up ok otherwise you wouldn't get a signal
to set it up on the box press MENU > SETUP > SERVICE SEARCHING > TUNER CONFIGURATION
select the first tuner and press ok then change configuration mode to advanced then use these settings
Satellite : Astra 2A/2B/2D/Eurobird 1 (28.2e)
Change LNB to LNB 1
Priority : Auto
LOF: Universal LNB
Voltage Mode: Polarization
Increased voltage: yes
Tone Mode: band
DiSEqC Mode: 1.2
Toneburst: None
Committed DiSEqC: None
Fast DiSEqC : no
Sequence repeat : no
Command order : committed toneburst
Uncomitted DiSEqC command : None
DiSEqC repeats : none
Longitude: 006.216 West
Latitude : 54:732 North
Use USALS for this Sat: Yes
then ok to save, go into the sat finder and select 28.2, it should move the dish and you should see the snr levels etc fill up on the screen, if it's ok go back into the tuner config and set it up for 13e & 19.2e using the same settings, if everything's ok you should be able to switch between all 3 satellites in the sat finder and get a decent signal
if it's ok go into manual scan (i think it's in the service searching menu) change it to single satellite then 28.2 and press ok to start the scan, you should get over 1000 channels, then do the same for 13e & 19.2e, you can add more satellites if you want but you might struggle to get a decent signal on some of them, the 3 i mentioned should get you everything you need anyway
you'll probably need to repeat the tuner config for the 2nd tuner in each box as well, not 100% sure mind as i've never used a twin tuner set up before but it seems logical to me